| Ismatec® BVP and MCP Quick-Couple Drives
Cole-Parmer®
- Mount pump heads quickly with turn-and-lock mounting system.
- Select from over 20 interchangeable tubing pump heads to achieve flow rates from 0.001 to 3700 ml / min.
- Control speed, start / stop pump or change flow direction remotely via analog signal.
- Choose from 4 drive types: BVP Standard, BVP Process, MCP Standard, MCP Process.
BVP Standard- Economical yet versatile drive lets you adjust speed in 0.1 % steps.
- Prime, flush or prevent overflow with max / slow toggle switch.
- Rear side interface: on / off, run / stop, direction, max / slow, 3-digit potentiometer for speed.
BVP Process- Microprocessor controlled drive features membrane keypad for speed setting.
- IP65-rated washdown pump - ideal for dusty, humid or corrosive environment and in cleanroom areas.
- Digital display shows speed.
- Sealed st. steel housing offers durability.
- Rear side interface: run / stop, direction, min / max, arrows for speed.
MCP Standard- Dispense by time, volume, flow rate, batches with variable pause time, stored programmes, roller backsteps or number of dispensing cycles.
- Use the RS232 interface to automate your lab or operate independently via the keypad - RS232 in for remote operation; RS232 out for cascading pumps.
- Digital display shows speed, flow rate, dispensing volume, dispensing time and pause time.
- Store and recall up to four programmes.
- Preprogrammed with tubing sizes and heads for faster setup.
- Rear side interface: on / off, run / stop, calibration, up arrow / down arrow, mode, max. / reset.
MCP ProcessSame as MCP Standard, but: - IP65-rated washdownpump - ideal for dispensing and filling in dusty, humid or corrosive environment and in cleanroom areas.
- Store and recall up to 4 programmes - using ProgEdit.
- Sealed st. steel housing provides durability.
- Rear side interface: run / stop, calibration, up arrow / down arrow, mode, max / reset.
- Pump can complete a programme-dispensing / pumping sequence created with ProgEdit - from 1 of 4 internal programme slots or from a remote PC.
| Technical Data: | | | Motor type: | DC motor | | Dimensions (without pump head): | 155 x 260 x 220 mm | | Power consumption: | 100 W | | Main supply: | 230 V AC, 50 Hz | Programmable:
BVP:
MCP: |
no
yes | | Flow rate settings (MCP types only): | µl / min, ml / min, l / min | | Speed: | 2.4 to 240 min-1 (BVP Standard)
1 to 240 min-1 (all other types) | | Resolution: | 0.1 % (via 3-digit potentiometer BVP Standard)
0.1 min-1 (all other types) | | Max. pump capacity: | 3700.00 [ml/min] | | Max. Drehzahl: | 240.00 [/ min] | | Material: | no indication | | Piston material: | no indication | | Cylinder material: | no indication | | Gear material: | no indication |
|
